What should we do if the vacuum oil filter fails in the oil equipment? In the following, Henan Huatai Cereals And Oils Machinery Co.,Ltd. introduced the possible or actual failures of the equipment during its operation and proposed a practical and effective solution to these problems.

1. The filter plate is damaged. If it is a large-area damage or is damaged one after another, it may be a material quality problem. Excluding this problem, it may be caused by pressure imbalance on both sides of the filter plate, improper selection, or clogging of the feed hole.
2. Spray between the filter plate; see if the filter cloth is damaged or thrown up and folded, not looking at the push plate is pressed.
3.  the oil control is not working or there is no temperature, the oil temperature thermometer is faulty or the heater is burned out, the line is disconnected, and the contact arm is not matched. • Disposal method 1. Check the circuit, replace the heater, and adjust the oil control.
4.  The oil discharge pump has no enough pressure oil; the cause of the fault is caused by the clogging of the small oil injection holes in the filter screen or the vacuum cylinder at the beginning of the trouble, and the solution clears the blockage.
5. The vacuum pump exhaust sound is abnormal, the exhaust valve is damaged or the screw is loose.
6. There is a bubble in the oil discharge or the pump does not produce oil. The first problem may be a shaft seal leak, and the second fault oil inlet fitting or pipe leak.
7. Oil equipment vacuum oil filter oil temperature indicator indicates that heating is slow or does not move, it may be that the oil temperature gauge is broken.